The ISO-PROTECT Site Hoarding System
ISO-PROTECT hoarding walls reliably cordon off your jobsite whether above-ground or underground. Experts praise it as a complete site security system which keeps away unauthorized personnel and curious spectators alike. ISO-PROTECT hoardings have a particularly modern and eye-pleasing appearance as compared to fences or screen barriers. ISO-PROTECT also serves as a routing system to direct crowd traffic at events such as trade shows, concerts, sports matches and other events. ISO-PROTECT’s smooth and easy-to-clean surface is an outstanding platform for messages of all types including corporate identity logos, advertising, crowd routing, identification of the building contractor, owner and/or architects, etc. etc.
Their portability, low transport weight and ease of installation make them the professional solution wherever quick dismantling and relocation are required. Their special design allows repeated reuse. ISO-PROTECT hoardings are weather-resistant, environment-friendly and 100 % recyclable. Wind tunnel tests conducted successfully at air speeds up to 135 km/h document their outstanding strength and durability.
| Product Programme | Hoarding Walls |
| Structured-core panel | ISO-PROTECT 10/2000 approx. 10 mm thick, area weight 2000 g/m² |
| Dimensions / design | 2.4 x 2.1 m / closed edges on top and one side. Colour: grey (approx. RAL 7001) or black (made with regrind resin) |
Installation of ISO-PROTECT Site Hoarding System
ISO-PROTECT hoarding: example of installation
Wherever your jobsite may be, on meadows, plowed farmland, sand, gravel, concrete, crushed rock or asphalt, ISO-PROTECT jobsite walls are ideally adaptable to all ground conditions and can be easily and quickly installed.
Step 1: The Support Frame
When installing ISO-PROTECT over nonpaved subsurfaces, use wooden posts 120 mm x 160 mm to anchor the hoarding wall system (against strong winds, rain, etc.). Drive the posts into the nonpaved subsurface at intervals of 2.4 m. Then screw 30 mm thick planking onto the posts at three different heights, providing a continuous support frame for the hoarding panels. We recommend installing the lowest planking row with a clearance of 300 mm above ground level. The upper edge of the highest planking row should be even with the upper edge of the ISO-PROTECT panels.
ISO-PROTECT panels are normally installed with a gap of 5 to 10 mm between adjacent panels to allow for thermal expansion. The panels can also be installed in an overlap configuration with 50 mm overlap at the joint.
Mounting of the panels on the support frame is best done using stainless-steel button head screws at least 45 mm in length and washers at least 26 mm in diameter. In some (outdoor) applications use of a ring seal is recommended with the washer. The required screw spacing depends on the forces and wind speeds expected at the site. Please refer to the table below.
| Requirements | Wind speed | Screws | Screw type | Foundation |
| Normal | up to 100 km/h | 12 screws (3 x 4) | 4.5 mm x 45 mm with seal and 26 mm finishing washer |
Strong anchoring and stable subsurface required |
| Heavy-duty | up to 135 km/h | 15 screws (3 x 5) | " | " |